1

For Mosquitoes, Flies and Gnats

An All Temperature, Quick Knockdown, Low Odor, Non-Corrosive Synergized Synthetic

Pyrethroid for the Control of Adult Mosquitoes, in Residential, Recreational, and Other Areas.

Also for Use Against Biting and Non-Biting Midge and Black Flies

For Application only by Public Health Officials and Trained Personnel of

Mosquito Abatement Districts and Other Mosquito Control Programs

2,2-dimethyl- cyclopropanecarboxylate, (+/-) cis (min) 35%, (+/-) trans (max) 65%..… … … … … … … … … .30.0%

Equivalent to 80% (butylcarbityl)(6-propylpiperonyl) ether and 20% related compounds… … … … … ..… … ..30.0%

Contains a Petroleum Distillate Solvent

Contains 2.5 lb. of Permethrin and 2.5 lb. of Piperonyl Butoxide per gallon.

KEEP OUT OF REACH OF CHILDREN

explicado ampliamente”

NET CONTENTS:

1.0 GAL 2.5 GAL ________ 30 GAL ________

2

Caution: Causes moderate eye irritation. Harmful if swallowed, absorbed through skin or inhaled. Avoid contact

with skin, eyes or clothing. Avoid breathing vapor or spray mist. Wash hands thoroughly with soap and water after

handling and before eating, drinking, chewing gum or using tobacco. Prolonged or frequently repeated skin contact

may cause allergic reactions in some individuals. Remove contaminated clothing and wash before reuse. Wear long

sleeved shirt and long pants, socks, shoes and chemical resistant (such as nitril or butyl) gloves.

poison control center or doctor. Do not give any liquid to the person. Do not give anything by mouth to an

unconscious person.

minutes. Call a poison control center or doctor for treatment advice.

present, after the first 5 minutes, then continue rinsing eye. Call a poison control center or doctor for treatment

advice.

respiration, preferably by mouth-to-mouth, if possible. Call a poison control center or doctor for further advice.

Have the product container or label with you when calling a poison control center or doctor, or going for treatment.

Note to Physician: Contains petroleum distillate – vomiting may cause aspiration pneumonia.

This product is extremely toxic to fish and aquatic invertebrates. Do not apply directly to water, to areas where

surface water is present or to intertidal areas below the mean high water mark. Do not apply when weather

conditions favor drift from treated areas. Drift and runoff from treated sites may be hazardous to aquatic organisms

in neighboring areas. Do not contaminate water when disposing of equipment wash waters. This product is highly

toxic to bees. Do not apply this product or allow it to drift to blooming crops or weeds while bees are actively

visiting the treatment area.

Note: Do not apply this product within 100 feet (30 meters) of fish bearing areas. Do not allow spray treatment to

drift onto pastureland, cropland, poultry ranges or water supplies.

Do not use, pour, spill or store near heat or open flame.

It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

Do not contaminate water, food or feed by storage or disposal.

temperatures. In case of spill or leakage, soak up with an absorbent material such as sand, sawdust, earth,

fuller’s earth, etc. Dispose of with chemical waste.

waste disposal facility.

and dispose of in a sanitary landfill or by other approved State and local procedures. (Plastic) Triple rinse or

equivalent. Then offer for recycling or reconditioning or puncture and dispose of in a sanitary landfill or

incineration, or if allowed by State and local authorities, by burning. If burned, stay out of smoke.

openings which have been opened during use.

3

TRUCK MOUNTED: Apply diluted or undiluted with suitable Thermal Fogging equipment. Do not exceed the maximum a.i./acre

rates. May be applied at speeds of 5 to 20 mph, treating a 300 ft. swath. To reduce oil requirement and sludge buildup in equipment,

use a suitable mineral oil of 60 – 100 second viscosity. For use with hand foggers, use the same a.i./acre rates and a swath width of 50 ft

with a walking speed of 2 mph. Do not wet foliage since the oil base formulation may be phytotoxic. Do not fog when wind conditions

exceed 10 miles per hour. Use well maintained and properly calibrated fogger. Fog downwind.

MACHINE OUTPUT

GAL/HOUR

DILUTION RATIO WITH

FOG OIL

5 MPH

DILUTION RATIO WITH

FOG OIL

10 MPH

MACHINE OUTPUT

DILUTION RATE

10 gal/hr 1: 79 1 : 39 0.25 gal/hr 1 : 15.5

20 gal/hr 1: 159 1 : 79 2.0 gal/hr 1 : 131

30 gal hr 1: 239 1 : 119 5.0 gal/hr 1 : 330

8.0 gal/hr 1 : 496

mosquitoes, flies and gnats in residential and recreational areas where these insects are a problem, such as, but not limited to parks,

campsites, woodlands, athletic fields, golf courses, residential areas, municipalities, gardens, playgrounds, recreational areas and

overgrown waste areas. For best results, treat when insects are most active and conditions are conducive to keeping the fog close to the

ground.

ranging in size up to 48 micron in diameter and mass medium diameter (MMD) up to 20 microns. If applying the product undiluted,

apply at a flow rate of 0.53 to 2.2 ounces per minute at an average vehicle speed of 10 mph. These rates are equivalent to 0.00175 to

0.007 pounds of permethrin and the same amount of 0.00175 to 0.007 pounds of synergist piperonyl butoxide per acre. If different

vehicle speed is used, adjust the rate accordingly. Vary flow rates accordingly to vegetation density and mosquito population. Use

higher flow rates in heavy vegetation or when populations are high. An accurate flow control system must be used to ensure proper

exceed the maximum pounds of active ingredient per acre as shown in the first column of the ULV table shown below. That table

represents some suggested application rates for ground ULV applications. If an alternative dilution rate is used, adjust the flow rate

accordingly.

5 mph 10 mph 20 mph

0.007/0.007 1.1 2.2 4.3

0.0035/0.0035 0.53 1.0 2.2

0.00175/0.00175 0.27 0.53 1.1

% CONCENTRATION Parts KONTROL 30 – 30 Parts Diluent Oil

2% 1 14

3% 1 9

4% 1 6.5

5 mph 10 mph 20 mph

0.007/0.007 8.1 16.3 32.6

0.0035/0.0035 4.0 8.1 16.2

0.00175/0.00175 2.0 4.1 8.1

4

5 mph 10 mph 20 mph

0.007/0.007 16.2 32.6 64.3

0.0035/0.0035 8.1 16.3 32.6

0.00175/0.00175 4.0 8.1 16.3

deliver particles of 50 – 100 Mass Medium Diameter. Use undiluted or diluted to achieve an application of 0.00175 / 0.00175 #

a.i./acre. Use a 50 ft (15.2m) swath while walking at a speed of 2 mph (3.2 kph). If using a different speed, swath or dilution, do not

exceed the maximum a.i./acre.

Such applications should be at the discretion of the Public Health Officials, Mosquito Abatement Districts or others trained in outdoor

mosquito and biting fly programs to protect public health. Applications cannot exceed the recommended rates. Aerial applications

should be by suitable aerial ULV equipment capable of producing droplets with an MMD of 50 or less, with no more than 2.5%

exceeding 100 micron. Flow rate and swath width should be set so as to not exceed 0.35 fluid ounces (0.007# a.i. per acre).

and Pest Control, Florida Department of Agriculture and Consumer Services.

of this label.

Univar USA, Inc.

11149 Research Blvd., Suite 260 EPA Registration Number: 73748-5

Austin, Texas 78759 EPA Establishment Number: 53883-TX-002